May 2016
It's Wired!
May/23/2016 Filed in: Phase III
We completed the connections to all the electronics; ignition, lights and the horn. Nothing like the simple days of common sense components. Especially if you’re willing to trade comfort, safety and reliability for pure fun!
Grill Welting
May/20/2016 Filed in: Phase III
Installed the Grill Welting with split rivets. It is a coated heavy cotton welting used on the top of the grill as a cushion for the hood to sit on.
Serial Number Data Plate
May/18/2016 Filed in: Phase III
Installed the all important Serial Number Data Plate. This identifies the model and serial number of the Jeep. They were not issued VIN numbers in those days.
Jerrycan Strap
May/15/2016 Filed in: Phase III
Installed a new Jerry Can strap after replacing the reproduction buckle with the original one from the old strap.
Vacuum Wipers Installed
May/08/2016 Filed in: Phase III
We installed the vacuum wipers. They are not the most reliable but that’s what they used sixty plus years ago!
It's a Jeep!
May/06/2016 Filed in: Phase III
It’s a Jeep! We installed the windshield and suddenly it looked like a jeep. The project was nearing completion and the anticipation for the first road trip was building!
Installed the New Coil
May/06/2016 Filed in: Phase III
Before the restoration the Jeep would cut out from time to time. It could have been fuel, or spark, but a few new components seemed prudent.
Replaced Themostat
May/05/2016 Filed in: Phase III
Replaced the Thermostat while in the process of fixing a coolant leak from one of the bolts in the thermostat housing.
New Distributor
May/04/2016 Filed in: Phase III
We decided to replace the distributor. After having some trouble getting the old one out, we struggled again trying to put the new one in until we discovered that the replacement had to be rotated 180 degrees! It turns out the oil pump slot is slightly off center.
